KawasakiTrax Community
General Category => CLASSIFIEDS: buy, sell or trade here => Topic started by: F500-92 on January 06, 2018, 04:30:22 PM
-
Flywheel puller bolts were too long and I messed up the lighting coil. At least I think it's the lighting coil. PM me a priceshipped to 48164.
-
Are the wires broken? Or is the insulation just scarred?
-
coil is cut through
-
actually... maybe not. I get 2 ohms on the yellow wires which the manual says are both ends of the coil. It may still be ok for now but I'd like a spare. it probably wont last long.
-
From what I can see in the pict:
while it may check out with an ohm meter, which is very low voltage and no amps, given a load it will surely burn through where the wires are mashed and are very thin. This area will now act as a fuse and even small current will heat the wire to a point of burning through.
I'd replace it or rewind it.
-
Replace for sure.
-
I believe I have some extra stators, PM me.