KawasakiTrax Community

General Category => General Discussion => Topic started by: mswyka on March 05, 2013, 11:53:47 AM

Title: Flywheel - Differences Between Intruder and Invader
Post by: mswyka on March 05, 2013, 11:53:47 AM

While I admit that I have not studied this, all flywheels look the same to me.  Does anyone know if there are any differences and whether or not I can interchange Invader and Intruder flywheels?

Title: Re: Flywheel - Differences Between Intruder and Invader
Post by: Lloyd (ljm) on March 05, 2013, 01:08:05 PM

 Should be no problem.

 I have used flywheels from T1 motors on T7 motors

Title: Re: Flywheel - Differences Between Intruder and Invader
Post by: jimvw57 on March 05, 2013, 11:52:01 PM

Main difference is the gear for the starter on the electric start ones, otherwise the 340, 440 ,invader, and intruder use the same part number from what i have seen.

Title: Re: Flywheel - Differences Between Intruder and Invader
Post by: mswyka on March 06, 2013, 03:52:48 PM

Quote from: jimvw57 on March 05, 2013, 11:52:01 PM

Main difference is the gear for the starter on the electric start ones, otherwise the 340, 440 ,invader, and intruder use the same part number from what i have seen.

Thank you.

Title: Re: Flywheel - Differences Between Intruder and Invader
Post by: mswyka on March 16, 2013, 09:32:31 AM

Well, I found out that the flywheel for the 80 LTD had a different ID than the flywheel on the 78 Invader.

Title: Re: Flywheel - Differences Between Intruder and Invader
Post by: Lloyd (ljm) on March 16, 2013, 11:24:20 AM

I ran into that once on my 80 440 Drifter.

 I think it was an 80 thing.

 I put a stator and flywheel of a 79 Intruder on my Drifter and it worked fine