Tech Information > So you got a "New to you Kawasaki snowmobile"
Oil injection line locations
11c:
I assume the cylinder oil lines go to the bottom of the intake tract between the carb and cylinder?
Of course mine are blocked off with bolts, one thing after another with this purchase... now I have to search for the nozzles >:(
gixxer6:
Yes, there is a oil port on the bottom of each cylinder on your Invader. There is also a port on the crankcase behind the water pump. Unfortunately it appears that the pump needs to be removed in order to install the one on the crankcase.
You will need nozzles and the check valve "banjos" for each. The banjos can be purchased from Polaris "Oil system Banjo: Same as Banjo for the 86 Polaris Indy 400. Polaris Part # 3083894"
11c:
Ok. ...thanks for the info
Boomologist:
This may help show the location. If what you see is an aluminum bolt going through a brass circle then you have the banjos and nozzles.
I would highly suggest getting a genuine copy of a Kawasaki shop manual for your sled. Re-establishing oil injection should involve a complete disassembly of the tank, pump, banjos and nozzles for cleaning and inspection. Re-assembling according to the manual with new hoses and clamps and filter. Then adjusting the cable to function properly with the throttle. It's not a big chore but one that will keep the engine lubricated far better than pre-mix.
11c:
I attempted to buy the only shop manual advertised around here but he sold it. $600 extra dollars sunk into this thing already without a single ride and it was advertised as ready to ride lol
One more question . ..
There are two outlet nozzils on the bottom of the oil tank, I assume one loops back to the top of the tank?
Navigation
[0] Message Index
[#] Next page
Go to full version