KawasakiTrax Community

Tech Information => General Help => Topic started by: Tory944 on December 21, 2014, 03:04:25 PM

Title: Factory jetting for the 79' 340 Invader
Post by: Tory944 on December 21, 2014, 03:04:25 PM

Hey guys...   got another sled with no carburetors!  Anybody have the factory jetting suggestions for this one?  I'd prefer to go with non econo jet carbs.  I have a feeling these carburetors may have been the standard mikunis...  Thanks in advance!           
                                       79' 340 Invader 8)

Title: Re: Factory jetting for the 79' 340 Invader
Post by: rminier on December 21, 2014, 03:57:04 PM

Yep, the 340's used standard VM-32's.
Main.         175
Needle.      6DH4-2
Needle jet.  P-4
Cutaway.    3 mm
Pilot.          25
Air screw.   1.5

This is what's listed in the 79 service manual...

Title: Re: Factory jetting for the 79' 340 Invader
Post by: Tory944 on December 21, 2014, 04:09:41 PM

Boy, I'll just start calling you the next time I need a question answered!  Thanks man! ;)

Title: Re: Factory jetting for the 79' 340 Invader
Post by: rminier on December 21, 2014, 04:14:48 PM

Watchin' my Indy Colts getting killed by the dang Dallas Cowboys...May as well pop open the old Invader manual.... :-[

Title: Re: Factory jetting for the 79' 340 Invader
Post by: Tory944 on December 21, 2014, 05:59:59 PM

Sorry to hear the bad news :'(  I always keep a few books around just in case 8)

Title: Re: Factory jetting for the 79' 340 Invader
Post by: gixxer6 on December 21, 2014, 07:27:39 PM

Tory, I've got a nice set of 79' 340 Invader carbs if your looking for some. 

Title: Re: Factory jetting for the 79' 340 Invader
Post by: Tory944 on December 22, 2014, 04:29:24 AM

$$???

Title: Re: Factory jetting for the 79' 340 Invader
Post by: Tory944 on December 22, 2014, 07:24:00 AM

Found a pair of 32's...   didn't even know I had!  Thanks for the help.