KawasakiTrax Community

General Category => General Discussion => Topic started by: Tory944 on March 16, 2015, 04:32:34 PM

Title: Alignment Tool
Post by: Tory944 on March 16, 2015, 04:32:34 PM

O.k.  Found a Kawi guy who wants a repro clutch alignment tool.  I need your email address or phone number.  This guy is not on Ktrax so I told him I'd locate one for him.  Think it was Trucker I bought one from, but can't remember for sure.  Old age thing.... ;)       Thanks!

Title: Re: Alignment Tool
Post by: dr1979-340 on March 16, 2015, 04:47:34 PM

I got mine from Interceptor398.  Worked like a charm.

Title: Re: Alignment Tool
Post by: Dandb7 on March 16, 2015, 05:14:11 PM

Hi Interceptor 398,

Do you still have one that i could purchase from you ?

Regards

Title: Re: Alignment Tool
Post by: Interceptor398 on March 16, 2015, 05:34:14 PM

I purchased the material for 6 more several weeks back and have been trying to work it into the mill.  Part of the trouble is most of the things I make are made of aluminum.  In the case of aluminum the chips must be clean or all you have is scrap.  This means I need to clean before and after I do something not made from aluminum.  Should be in the next couple weeks with some luck. They are exact copies but this time I will do a couple with several holes in them to lighten them up for shipping to Canada.  The goal is to get the package under 4 pounds.  If it's over 4 the shipping cost goes thru the roof.

Title: Re: Alignment Tool
Post by: Dandb7 on March 16, 2015, 05:48:17 PM

Sounds good...keep me posted and please secure one for me ...thanks!

Title: Re: Alignment Tool
Post by: Tory944 on March 16, 2015, 06:17:56 PM

Could I get your email address so I can forward it to the Kawi guy that inquired?  Thanks.    ;)

Title: Re: Alignment Tool
Post by: Interceptor398 on March 16, 2015, 07:27:17 PM

wildrivermachine@centurytel.net

Title: Re: Alignment Tool
Post by: Tory944 on March 17, 2015, 03:38:21 AM

Thanks.  I will have him contact you.

Title: Re: Alignment Tool
Post by: Interceptor398 on April 15, 2015, 12:44:10 PM

I finished 6 tools.  They are $60.00 each plus shipping.  Seems a little steep but doing these is a pay cut at this price.  Material is $15.00 each plus a $150.00 cutter means I pocket very little this time around.  1 of the tools is less than perfect in the cosmetic department but will work fine so will sell for a little less.

Title: Re: Alignment Tool
Post by: foxspoiler on April 15, 2015, 04:58:14 PM

Bob, I will take one. could I meet you over at St.Croix Walmart or somewhere to pick up.

thanks
Mike

Title: Re: Alignment Tool
Post by: Interceptor398 on April 16, 2015, 08:02:25 AM

Quote from: foxspoiler on April 15, 2015, 04:58:14 PM

Bob, I will take one. could I meet you over at St.Croix Walmart or somewhere to pick up.

thanks
Mike

I have one with your name on it as you had shown interest before.