KawasakiTrax Community

Tech Information => General Help => Topic started by: wisc79intruderguy on December 19, 2015, 07:23:57 PM

Title: Stock jetting for 440 intruder with vm 34 carbs
Post by: wisc79intruderguy on December 19, 2015, 07:23:57 PM

Hello all I'm wondering what year intruder had the 34 mikunis and what was the stock jetting clip position etc thanks. I'm switching to a non power jet carbs on my intuder with 32s

Title: Re: Stock jetting for 440 intruder with vm 34 carbs
Post by: wisc79intruderguy on December 19, 2015, 10:39:05 PM

Anyone?

Title: Re: Stock jetting for 440 intruder with vm 34 carbs
Post by: rminier on December 20, 2015, 04:50:48 AM

 I don't have the 82 Intruder manuals, but the others, from 1978 to 1981 show that all those models used twin VM-32 power (econo) jet carbs for the Intruder. The only differences are a slight reduction in the factory jetting from 78 to 79. Kawasaki must have felt they went a little too conservative with the 1st year 1978, and could drop back slightly on the jetting. All those years from 78 to 81 show the stock clip position on the jet needle was the 3rd position.

Title: Re: Stock jetting for 440 intruder with vm 34 carbs
Post by: Interceptor398 on December 20, 2015, 01:09:56 PM

Jetting depends on the year and if it's the left or right carb, what does the tag on the motor say?

Title: Re: Stock jetting for 440 intruder with vm 34 carbs
Post by: wisc79intruderguy on December 20, 2015, 01:16:47 PM

The sleds a 80 I want to switch to non power jet 34s mikunis that's why I need the jetting for my 440 fan in my intruder. Thanks

Title: Re: Stock jetting for 440 intruder with vm 34 carbs
Post by: Interceptor398 on December 21, 2015, 08:07:05 AM

A 1980 Intruder motor tag will say TA440C-C201. 

Left carb is marked L32/164  Main jet 145,  Pilot jet 25,  Power jet 140RRT,  Jet needle  6 DH7-3
Right carb              R32/165  Main      145,  Pilot     25,  Power jet  120RRT  Jet needle   6 DH7-3

This is more info than you were asking for.

Title: Re: Stock jetting for 440 intruder with vm 34 carbs
Post by: wisc79intruderguy on December 21, 2015, 10:44:50 AM

Thanks ill start with those specs.