KawasakiTrax Community

General Category => CLASSIFIEDS: buy, sell or trade here => Topic started by: F500-92 on January 06, 2018, 04:30:22 PM

Title: WTB lighting coil... I think...
Post by: F500-92 on January 06, 2018, 04:30:22 PM

Flywheel puller bolts were too long and I messed up the lighting coil.  At least I think it's the lighting coil.  PM me a priceshipped to 48164.

Title: Re: WTB lighting coil... I think...
Post by: mswyka on January 06, 2018, 05:07:57 PM

Are the wires broken?  Or is the insulation just scarred?

Title: Re: WTB lighting coil... I think...
Post by: F500-92 on January 06, 2018, 05:55:18 PM

coil is cut through

Title: Re: WTB lighting coil... I think...
Post by: F500-92 on January 06, 2018, 06:15:25 PM

actually... maybe not.  I get 2 ohms on the yellow wires  which the manual says are both ends of the coil.   It may still be ok for now but I'd like a spare.  it probably wont last long.

Title: Re: WTB lighting coil... I think...
Post by: Boomologist on January 07, 2018, 12:17:23 AM

From what I can see in the pict:
while it may check out with an ohm meter, which is very low voltage and no amps, given a load it will surely burn through where the wires are mashed and are very thin. This area will now act as a fuse and even small current will heat the wire to a point of burning through.
I'd replace it or rewind it.

Title: Re: WTB lighting coil... I think...
Post by: Interceptor398 on January 07, 2018, 08:09:17 AM

Replace for sure.

Title: Re: WTB lighting coil... I think...
Post by: gixxer6 on January 07, 2018, 10:23:16 AM

I believe I have some extra stators, PM me.