Clutch puller?

[swedefire]

Does anyone know what threads the primary clutch has, I think Ill go with the water/oil trick..?

Thanks!

[The Great Jashu]

The Kawasaki clutch puller is the only one that will work. The are available for about $15 from Dennis Kirk or Shadetree. Cheap investment.

[Invader440]

Invader/Intruder/Interceptor - Kawasaki clutch tool.  All others use the Arctic Cat hex clutch tool except the 81 Drifter which had it's own puller.

[Drifter]

I brought mine to the local Brafasco and the bolt to try the water trick was $24.00 and they didn't stock them. The proper clutch puller is less than $20.00.  Needless to say the proper ones on its way.

[Drifter]

My Brafasco dealer checked the thread with a tap and said it was M14 x 1.5 pitch but I was thinking later that if it was an Arctic cat clutch than why would it be metric?  I left Release All in the hole for the clutch for a few days and it came off with little effort.

[Invader440]

My Brafasco dealer checked the thread with a tap and said it was M14 x 1.5 pitch but I was thinking later that if it was an Arctic cat clutch than why would it be metric?  I left Release All in the hole for the clutch for a few days and it came off with little effort.

Hex clutch puller would have 9/16-18 threads.

[swedefire]

To answer my own question...the threads on the kawa made clutch is M18 x1,5mm i used the water trick and it is just super easy...  Now mowing on to engine disassembly...

Thanks!