So this sled has been all work and no fun
When i bought the sled; The previous owner said he had put brand new crank seals in, But as i cleaned up everything i am starting to question what he said.
He had told me that it needed a carb cleaning then it would run great (So the quest Begins!) I broke down and cleaned the carbs, Put them back on and it runs the same as if i just left the carbs dirty. So i went down the list (Spark- check, fuel- check, carb boots- good, vacuum leaks- none and timing- good.)
So the problem is... Engine will start, but only the pto side is combusting, then at 4000 rpm the mag cyclinder seem to come in. Am i right to assume if everything else checks out; That the mag side seal is bad.
So much for just having a little fun, before putting in a bunch of work rebuilding